Computational Approach to Investigation of Crack Behaviour under Vehicular Loading of A Typical Concrete Pavement (A Case Study of Mbagathi Road in Nairobi)
DOI:
https://doi.org/10.18034/ra.v3i2.294Keywords:
Pavement, Cracks, Tensile stresses, aggregate, interlockAbstract
Nairobi County has nearly 100% road network as bituminous roads and only 4km road network (Mbagathi Road) is concrete road. This road was a pilot project that was implemented by Kenyan Government between the years 2005 and 2007 at a total construction cost of over 400 million Kenya Shillings. The design was done based on South Africa design procedure on a 210 mm thick PJCP pavement. Performance of Plain Jointed Concrete Pavement (PJCP) depends on aggregate interlock, which is the mechanism by which loads are transferred from one slab to the adjacent one. This study attempted to use the information on load transfer mechanics in order to quantify the effect of aggregate properties to crack size as well as the propagation of any cracks formed in service. This research was undertaken in two different ways namely experimental and computer simulation. The experimental approach entailed measuring widths and depths of cracks existing in Mbagathi road, and also involved setting up concrete beams in the laboratory and loading them to failure with predetermined loads and measuring sizes of resulting cracks. On the other hand, the computational approach was verified by experimental results entailed simulating crack widths and depths with recent devised fracture models. Cracks were experimentally noticed to occur due to loading the pavement with vehicular loads bigger than safe load. Cracks generated had crack width equivalent to the measured flexural deflection and for an ideal concrete pavement crack width and crack depth exhibited an exponential relationship. It was found that vehicular loads induce stresses in concrete pavements which exceed permissible tensile stresses, hence a better understanding of the resultant cracks, as well as their propagation. This research will lead to an improvement of the design of concrete pavements in Kenyan environment.
Downloads
References
Dura, C., Durability Design of Concrete Pavements, Project BE95-1347/R14B, 2000.
Manual, M10, Concrete Pavement Design and Construction, Department of Transport, Pretoria, 1995.
Yang, H. H., Pavement Analysis and Design Second edition, Prentice Hall Pub, 2003
Kare, H., Introduction to Fracture Mechanics, McGraw-Hill Inc. US, 1984
Zdenek, P. B., Fracture Mechanics of Concrete Structures, Elsevier Applied Science, London and New York, 1992.
Zdenek, P. B., Crack Band Theory for Fracture of Concrete, Northwestern University, ABC Research Alert, Volume 3, No 2/2015
Norbert J. D., Concrete Pavement Design, Construction and Performance Second Taylor and Francis, 2008.
Guo H, J. A. Sherwood, and M.B. Synder,” Component Dowel Bar Model for Load Transfer Systems in PCC Pavements,” Journal of Transportation Engineering, pp.287-297, May/June 1995.
Miner, M., Cumulative Damage in Fatigue. American Society of Mechanical Journal of Applied Mechanics, 12 (3), 1945.
Alex, G., A Mechanistic- Empirical Tie Bar Design Approach for Concrete Pavements, Applied Research Associates, 2009.
BS 1881: Part 203, Recommendations for Measurement of the Velocity of Ultrasonic Pulses in Concrete, London, 1986.
Tada, H., P.C. Paris and G.R. Irwin., The Stress Analysis of Cracks Handbook. ASME Press, New York, 2008.
Bazant, Z.P., and Pfeiffer, P.A.,”Determination of Fracture Energy Properties from Size Effect and Brittleness Number,” ACI Mater. J.,V.84, No.6, pp.468-480, 1987.
Farmington, H. M., , Control of cracking in concrete, American concrete institute, 1990.
Shah S.P., McGarry F.J., Griffith Fracture Criterion and Concrete, Journal of the Engineering Mechanics Division. ASCE Vol.97. No.EM6, Proc. Paper 8597, pp.1663-1676, Dec. 1971.
Rice, J. R., A Path Independent Integral and the Approximate Analysis of Strain Concentration by Notches and Cracks. Transactions of ASME, Journal of applied: 379-386, 1968.
Seong H. S., Paulino, G.H., and Buttlar, W.G, Simulation of crack propagation in concrete using intrinsic cohesive zone model, Transportation Research Board, Washington D.C, 2007.
Sansalone M. J., Lin J. W. B Street, Determining the Depth of Surface Openings Cracks Using Impact Generated Stress Waves and Time of Flight Technique,” ACI Materials Journal. V.95.No.2., 1998.
Shin, S.W., Popovics, J. S., Crack Depth Determination in Concrete Using Energy Transmission of Surface Waves, ACI Materials. Vol.105.No.5, 2008.
Arne Hillerborg., Application of Fracture Mechanics to Concrete, Summary of a series of lecture notes, 1988.
--0--
Downloads
Published
Issue
Section
License
ABC Research Alert is an Open Access journal. Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal the right of first publication with the work simultaneously licensed under a CC BY-NC 4.0 International License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of their work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal. We require authors to inform us of any instances of re-publication.
